Structural Laminating Epoxy
Low-viscosity laminating system for structures in glass, carbon, aramid, basalt and natural fibres.
A low-viscosity laminating system for high-performance structures in glass, carbon, aramid, basalt and natural fibres, from small parts to very large ones. Six hardeners share one ratio and can be blended to set the working time. Parts release from the mould without post-curing; a 60 °C post-cure brings out the best thermo-mechanical properties. No CMR substances.
Datasheets available on request
Key benefits
- Wet lay-up, infusion, injection or filament winding
- Six hardeners, one ratio: blend them to set pot life from 13 min to 13 h
- Low viscosity, low exotherm, excellent air release
- Releases from the mould without post-curing; post-cure at 60 °C for peak properties
- No CMR substances
Pack sizes
1.35, 6.75 and 37.8 kg kits; drums and IBCs
Supplied to order: contact us for stock and lead times.
Pairs with
Specifications
| Mix ratio | 100 : 35 by weight |
|---|---|
| Gel time | 13 min to 13 h, by hardener |
| Mix viscosity | 239 to 537 mPa.s |
| Tg, 16 h at 60 °C | 67 to 86 °C |
| Processes | Lay-up, infusion, injection, winding |
| Hardeners | Summer, year-round and winter options |
| Bio-based carbon* | 36% resin part, 27 to 28% mixed |
* Bio-based carbon is the share of carbon atoms that come from plant sources rather than fossil sources. "Resin part" is Part A on its own; "mixed" covers resin and hardener together and is usually lower, because most hardeners contain less bio-based carbon. Figures from the manufacturer's technical datasheets. The Crystal Clear Epoxy figure is tested to ASTM D6866.
CMR means carcinogenic, mutagenic or toxic to reproduction.
Technical data from the manufacturer's datasheets, measured at 23 °C unless stated. Always test before use and read the safety data sheet.