Crystal Clear Epoxy
Crystal-clear laminating and coating system for visible carbon and high-gloss clear coats.
A crystal-clear laminating and coating system with good UV stability. Absolutely clear on carbon fibre, it levels to a bubble-free finish by squeegee, brush or roller, and leaves virtually no free amines, so polyester finish coats cure on top without inhibition. Made for laminates and coatings in thin layers, not deep casting.
Datasheets available on request
Key benefits
- Absolutely clear on carbon fibre, with good UV stability
- Levels to a bubble-free finish by squeegee, brush or roller
- Virtually no free amines, so polyester finish coats cure on top without inhibition
- 42% bio-based carbon in the resin part, tested to ASTM D6866*
Pack sizes
1.35, 2.7, 6.75 and 33.75 kg kits; drums and IBCs
Supplied to order: contact us for stock and lead times.
Pairs with
Specifications
| Mix ratio | 100 : 35 by weight |
|---|---|
| Gel time | 28 min; 2 h 50 min as a 2 mm film |
| Mix viscosity | 700 mPa.s |
| Tg, 16 h at 60 °C | 78 °C |
| Hardness | Shore D 86 to 88 |
| Water absorption, 24 h | 0.36% |
| Bio-based carbon* | 42% resin part, 31% mixed |
For laminates and coatings in thin layers, not deep casting.
* Bio-based carbon is the share of carbon atoms that come from plant sources rather than fossil sources. "Resin part" is Part A on its own; "mixed" covers resin and hardener together and is usually lower, because most hardeners contain less bio-based carbon. Figures from the manufacturer's technical datasheets. The Crystal Clear Epoxy figure is tested to ASTM D6866.
CMR means carcinogenic, mutagenic or toxic to reproduction.
Technical data from the manufacturer's datasheets, measured at 23 °C unless stated. Always test before use and read the safety data sheet.