Water-Based Spray Filler
Sprayable epoxy filler for models, patterns, sets and direct moulds.
A sprayable, water-based epoxy filler for models, patterns and direct moulds. It goes onto polystyrene, foam, wood, composite or wax without attacking it, sands very easily and replaces solvents with water. Seal it with Water-Based Epoxy Paint to close the surface.
Datasheets available on request
Key benefits
- Safe on polystyrene, so there's no seal coat to put on first
- No VOC or CMR components
- Up to 1.7 mm per coat, several coats a day
- Dry to touch in 45 min, hard and sandable in 12 to 24 h
- Spray, brush, roller or spatula; thins with water
Pack sizes
0.6, 3.6, 12.1 and 18.2 kg kits
Supplied to order: contact us for stock and lead times.
Pairs with
Specifications
| Mix ratio | 100 : 21 by weight |
|---|---|
| Pot life | 5 h |
| Dry to touch | 45 min |
| Hard and sandable | 12 to 24 h |
| Max per coat | 1.7 mm |
| Thinning | Water: 5% for brush, 20% for spray |
| Emissions | No VOC or CMR components |
Dry times measured undiluted on polystyrene at 23 °C.
Our water-based products replace solvents with water and contain no VOCs. We don't describe them as bio-based.
CMR means carcinogenic, mutagenic or toxic to reproduction.
Technical data from the manufacturer's datasheets, measured at 23 °C unless stated. Always test before use and read the safety data sheet.